Today we will be going over the steps on how to change the Single Stage Filter on your Pure Blue Single Stage system.

Prepare your area by placing towels or paper towels beneath your system to catch any remaining water.

The first step is to shut off the water supply to your system. Locate the shut off valve for your feed and turn it off.
Next, release the pressure in your system by opening the spigot and letting it drip. Once the dripping has stopped, close the spigot.
Remove the old filter by turning it CLOCKWISE until filter is clear of the manifold.
Now it is time to install the new filter. Begin by removing the yellow cap on top of the filter. Install the new filter into the appropriate slot and turn the filter Counter Clockwise until the filter is hand tight.
With the spigot open and the new filter installed, turn the feed back on. Once there is a thin drizzle from the spigot, turn the spigot back off and wait 10 minutes, checking thoroughly for any leaks.
If no leaks have been detected after 10 minutes, open the spigot and complete the final flushing procedure.
Let the system run for 10 minutes with the spigot open and the feed valve on in order to flush the new filter.
After 10 minutes, close the spigot.
Your Pure Blue Single Stage Drinking Water System is ready to be used again.